Mitsubishi Electric MELCEC Q Series - Software Package

2 - 4
2. SYSTEM CONFIGURATION
2.2.2 Software package
(1) GPP function software packages and model name setting at the start-up
The following table shows the GPP function software package that can be used to
create the QCPU-A program, and the programmable controller type setting at start-
up.
When using SW4D5C-GPPW or later, select the programmable controller type from
Q02(H)-A or Q06H-A according to the CPU to be used.
When using the peripheral devices and GPP function software package of SW3D5C-
GPPW or earlier, specify the programmable controller type name as "A4U". If "A4U"
is not found in PLC type names, specify "A3A." If both "A4U" and "A3A" are not
found, specify "A3H."
Note that when "A4U" is specified, the available device range is limited.
Peripheral
device
Software package for system start-up
Programmable controller CPU
model setting
Q02(H)-A Q06H-A
PC/AT
personal
computer
SW4D5C-GPPW or later Q02(H)-A Q06H-A
SW3D5 -GPPW or earlier
A4U A4U
SW IVD-GPPA
A6PHP SW3GP-GPPA A3H A3H
SW4GP-GPPA A3A A3A
SW1GP-GPPAU A4U A4U
A6GPP SW3-GPPA
SW3GP-GPPA
A3H A3H
SW4GP-GPPA A3A A3A
SW1GP-GPPAU A4U A4U