Appendix 1. Cable and Connector Specifications
A1 - 24
(7) Tightening angle back shell
[1] Temporarily tighten the back shell coupling on the angle back shell.
* To prevent loosening, Adhesive should be applied to the angle back shell.
[2] Set the angle back shell on the tightening guide.
[3] Set the back shell wrench on the back shell coupling.
[4] With the wrench, tighten the back shell coupling on the angle back shell.
Recommended tightening torque: 5N•m
(Note) Accurately fit the wrench on the back shell coupling.
To remove, take the reverse steps.
* Recommendation
Adhesive
(2 threads around
the circumference)
Temporar y
tightening
Back shell
coupling
Tightening guide
Set
Tightening guide
Torque wrench
Tighten
Angle back shell
wrench
19
17
* Referential dimensions for back
shell tightening guide
Back shell width
22
Thickness:
10 or more
* Recommendation:
Tightening guide
(357J-50508T)
• Recommended jigs and tools: Back shell wrench (357J-51333T)
Bit (357J-51344T)
Torque wrench (CL6N x 8D,Tonichi Mfg.)
* Recommended tightening guide: (357J-50508T)
* Recommended adhesive: screw lock 1401B (Threee bond Co,Ltd)
Set
ngle back shell
(Note) To change the back shell angle, adjust the toothing position of the plug shell
and back shell.
To Next Page
Loading...
