Appendix 1. Cable and Connector Specifications
A1 - 26
(9) Tightening a clamp nut
[1] Temporarily tighten the clamp nut on the angle back shell.
* To prevent loosening, the adhesive should be applied to the back shell.
[2] Set the angle back shell on the tightening guide.
[3] Set the clamp nut wrench on the clamp nut.
[4] With the wrench, tighten the clamp nut on the angle back shell.
Recommended tightening: 5N•m
(Note) Accurately fit the wrench on the clamp nut.
To remove, take the reverse steps.
* Recommendation
Adhesive
(2 treads around the
circumference)
Temporary
tightening
Tightening guide
Set
Torque wrench
Tighten
19
17
* Referential dimensions for bac
shell tightening guide
Back shell width
22
Thickness:
10 or more
* Recommendation:
Tightening guide
(357J-50508T)
● Recommended jigs and tools: Clamp nut wrench (357J-51334T)
Bit (357J-51345T)
Touque wrench (CL6N x 8D,Tonochi Mfg.)
* Recommended tightening guide: (357J-50508T)
* Recommended adhesive: Screw lock 1401B (Tree bond Co.Ltd)
Set
ngle
Back shell
Tightening guide
Clamp nut wrench
Clamp nut
To Next Page
Loading...
