Mitsubishi Electric Melsec-F FX2NC Series - Page 25

FX2NC Series Programmable Controllers Introduction 1.
1-13
Note
When connecting peripheral equipment (programming tool or GOT [direct connection to
CPU]) via the FX
2NC
-232ADP or the FX
0N
-232ADP, FX
2NC
main unit should be the following
setting condition.
- Set the special data register for the communication format setting of the channel
connecting the peripheral equipment (D8120) to K0.
- Set the communication parameter to "Not set".
Table 1.7 : Configuration notes
A
MPU-Main unit (Main Processing Unit)
c
Left hand side port
B
Extension block, Special function block
d
Memory port
C
Connector conversion adapter
e
Programming port
D
Extension block
f
I/O port
E
Special function block
g
MPU bus port
F
Function adapters
h
Unit bus port
G
Memory board (Real time clock)
H
Data access units, GOT
I
Dedicated programming
J
Computer interface
K
Computer software
L
Terminal block