Mitsubishi Electric MELSEC iQ-F FX5 - Chapter 1 Function Block (Fb) List; Chapter 2 Input;Output Fb; M+FX5 UCPU-Io_Outputontimes

2
1 FUNCTION BLOCK (FB) LIST
1 FUNCTION BLOCK (FB) LIST
This chapter lists the FBs for the MELSEC iQ-F series FX5U, FX5UC CPU module.
Input/Output FB
*1 Note that this reference does not describe the FB version information which is displayed such as "_00A" at the end of FB name
Positioning FB
*1 Note that this reference does not describe the FB version information which is displayed such as "_00A" at the end of FB name
Serial Communication FB
*1 Note that this reference does not describe the FB version information which is displayed such as "_00A" at the end of FB name
High-speed Counter FB
*1 Note that this reference does not describe the FB version information which is displayed such as "_00A" at the end of FB name
Precautions
If upgrading module FB versions updates instructions, adds a new instruction, or adds a new device, please use the GX
Works3 corresponding to the latest module FB.
Name
*1
Description
M+FX5UCPU-IO_OutputOnTimes This FB counts (cumulatively) the number of ON times of the specified relay device number within the
range from 0 to 4294967295.
M+FX5UCPU-IO_CompareRelayOnTimes • This FB counts (cumulatively) the number of ON times of the specified relay device number within the
range from 0 to 4294967295.
• This FB compares the counted number of ON times with the set value, and outputs the comparison
result.
Name
*1
Description
M+FX5UCPU-Positioning_ABRST This FB reads the absolute position (ABS) data from the servo amplifier, and writes the read value to the
current address (pulse unit) of the target axis.
M+FX5UCPU-Positioning_StartPositioning This FB uses the table data set using the module parameters to activate the positioning operation.
Name
*1
Description
M+FX5UCPU-SerialComm_InputOutput This FB stores the received data and sends the specified number of data points using non-protocol in
serial communication.
M+FX5UCPU-SerialComm_Input This FB stores the data received using non-protocol in serial communication.
M+FX5UCPU-SerialComm_Output This FB sends the specified number of data points using non-protocol in serial communication.
M+FX5UCPU-SerialComm_ExeCommonProtocol This FB executes the protocol registered with GX Works3.
Name
*1
Description
M+FX5UCPU-Counter_PulseMeasure This FB starts the pulse measurement function, and stores the pulse measured value.