Mitsubishi Electric MELSEC-Q Series - 1 Outline; 2 System Configuration; 3 Got; System Applications that Are Automatically Selected

5/35
BCN-P5999-0176-2a
1. OUTLINE
This manual explains the sample screens of GOT2000 connected to a MELSEC-Q Series PLC (Q06UDEHCPU)
via Ethernet. The sample screens can be used for monitoring the status of each axis and the buffer memory
(including current values and alarms) of Simple Motion Module (QD77MS16).
2. SYSTEM CONFIGURATION
*1: The SD card is used for the document display function.
*2: The battery is used for the backup of the clock data. (The battery is provided with the GOT as standard.)
*3: For more details about the cable, please refer to the "GOT2000 Series Connection Manual (Mitsubishi
Products)".
3. GOT
3.1 System Applications That Are Automatically Selected
Type
System application name
Standard Function
Standard System Application
Standard Font
Japanese
Communication Driver
Ethernet Connection
Ethernet (MELSEC), Q17nNC, CRnD-700, Gateway
Extended Function
Standard Font
Chinese (Simplified)
Outline Font
Gothic
Alphanumeric/Kana
Japanese (Kanji)
Chinese (Simplified)
Document Display
3.2 Controller Setting of Screen Design Software
Detail Setting
Item
Set value
Remarks
GOT NET No.
1
GOT Station No.
2
GOT Ethernet Setting
Refer to table below
GOT Communication Port No.
5001
Retry (Times)
3
Startup Time (Sec)
3
Timeout Time (Sec)
3
Delay Time (ms)
0
GOT Ethernet Setting
Item
Set value
Remarks
Reflect GOT Ethernet setting in the GOT
Checked
GOT IP Address
192.168.3.18
Subnet Mask
255.255.255.0
Default Gateway
0.0.0.0
Peripheral S/W Communication Port No.
5015
Transparent Port No.
5014
GOT2000
 GT27**-V (640 X 480)
 Interface:
Standard I/F (Ethernet)
 SD card *1
 Battery (GT11-50BAT) *2
Ethernet cable *3
 Q06UDEHCPU
 QD77MS16
Servo Amplifier