Mitsubishi Electric MELSERVO-J5 HK Series - Permissible Load for the Output Shaft

114
6 HK-KT SERIES
6.1 Standard specifications
Permissible load for the output shaft
The permissible load for the shaft is shown in the following. Do not subject the shaft to loads greater than the permissible
value. The value assumes that the load is applied independently.
In case where the load position changes, calculate the permissible radial load from the distance measured from the flange
mounting surface to the center of the load, and make the load equal to or less than the permissible radial load, referring to the
graph shown in the following.
Model Radial load Thrust load The graph of the relation between the load and the load
position
Load position L
[mm]
Load [N] Load [N]
HK-KT053W
HK-KT13W
HK-KT1M3W
HK-KT13UW
25 88 59
HK-KT23W
HK-KT43(4)W
HK-KT63(4)W
HK-KT23UW
HK-KT43UW
30 245 98
Distance L from flange mounting
surface to load center
Radial load
Thrust load
80
85
90
95
100
105
110
115
120
125
0 5 10 15 20 25
Permissible load [N]
Distance L from flange surface [mm]
220
240
260
280
300
320
340
0 5 10 15 20 25 30
Permissible load [N]
Distance L from flange surface [mm]