44
4 CONNECTING THE SERVO AMPLIFIER AND ROTARY SERVO MOTOR
4.2 Wiring
*1 Configure a circuit which interlocks with an emergency stop switch to shut off.
*2 The electromagnetic brake terminals (B1 and B2) have no polarity.
*3 Do not use the 24 V DC interface power supply for the electromagnetic brake.
*4 Connect a surge absorber as close to the rotary servo motor as possible.
*5 For MR-AENSCBL_M-_, refer to the following.
Page 83 MR-AENSCBL_M-_
*6 Use of the following connectors is recommended:
*7 This connection is for the MR-J5 3-axis servo amplifier.
Junction connector Description IP rating
a) Junction connector for extension cable IP67
b) Junction connector for motor power
cable
IP67
Connector: CE05-6A22-23SD-D-BSS
Cord clamp: CE3057-12A-2-D
(DDK Ltd.)
The number varies depending on the cable OD.
Connector: D/MS3101A22-23P(D263)
Backshell: CE02-22BS-S-D
Cord clamp: CE3057-12A-3-D
(DDK Ltd.)
The number varies depending on the cable OD.
To Next Page
Loading...
