Mitsubishi Electric MELSERVO-J5 - Page 17

1 FUNCTION
1.1 Function explanation
15
1
*3 This function is not available for CC-Link IE TSN Class A.
*4 When the safety sub-function by a network is used (when [Pr. PSA01.1 Input mode selection] is set to "1"), this function is not available.
Positioning function
*1 "Ver." indicates the supported firmware version of the servo amplifier. The functions are available on servo amplifiers with the indicated
firmware version or later.
Functions Detailed functions Description Ver.
*1
Detailed explanation
[G] [B] [A]
J5 J5D
Override function Override function This function can change the servo motor
speed via communication. The value can be
changed to 0% to 360% of the set speed.
D4 D4 Page 382
APPLICABLE
FUNCTIONS
Absolute position Infinite feed function In an absolute position detection system, even
if the servo motor rotates 32768 rev or more in
the same direction, [AL. 0E3.1 Multi-revolution
counter travel distance exceeded warning] will
not occur and the home position will not be
erased. Therefore, the current position will be
restored after the power is cycled. When this
function is not used, if the servo motor rotates
32768 rev or more in the same direction, [AL.
0E3.1] will occur and the home position will be
erased.
B6 C0 Page 364 Infinite feed
function [G]