To Next PageTo Next PageWhy does my Mitsubishi Electric Servo Drive display error AA?
The AA error on your Mitsubishi Electric Servo Drive can occur for several reasons: * The power to the servo system controller might be off. Ensure it is switched on. * The SSCNET III cable could be disconnected. If so, replace the SSCNET III cable of the affected axis. * The power to the servo amplifier might be off. Verify that the servo amplifier is powered on.
What to do if Mitsubishi Electric Servo Drive shows error Ab?
The Ab error on your Mitsubishi Electric Servo Drives indicates a communication or configuration problem. Here's what you should check: * Ensure that the disabling control axis switches (SW2-2, 2-3, and 2-4) are turned off. * Verify that the Axis No. is set correctly. * Confirm that the Axis No. matches the axis No. set in the servo system controller. * Make sure the information about the servo series is set in the simple motion module. * Ensure the communication cycle matches. * If using MR-J4W3- _B with software version A2 or earlier, use a 0.444 ms or more communication cycle. * Check and replace the SSCNET III cable of the corresponding axis if it's disconnected. * Verify that the servo amplifier is powered on. * If the servo amplifier is malfunctioning, replace it.
What does error code 'Ab AC or Ab AC Ad' mean on Mitsubishi Electric MR-J4W2-22B Servo Drives?
This error indicates that an MR-J4-_B(4)(-RJ) servo amplifier or MR- J4W_-_B servo amplifier set to J3 compatibility mode is connected to the SSCNET III/H network. To resolve this, select "J4 mode" using the "MR- J4(W)-B mode selection" setting.
How to disable test operation mode on Mitsubishi Electric MR-J4W2-22B Servo Drives?
If your Mitsubishi Electric Servo Drive displays the error ‘b##. (Note)’, it means the test operation mode is active. To disable it, turn off the test operation setting switch (SW2-1).
Why is my Mitsubishi Electric Servo Drive showing 'off' error?
The 'off' error on your Mitsubishi Electric Servo Drive indicates that the operation mode for manufacturer setting is enabled. To fix this, set the control axis setting switches (SW2) correctly.
General| Model | MR-J4W2-22B |
|---|---|
| Series | MR-J4 |
| Type | Servo Drive |
| Rated Output | 2.2 kW |
| Number of Axes | 2 |
| Protection Class | IP20 |
| Communication | SSCNET III/H |
| Feedback | Absolute/Incremental Encoder |
| Power Supply Voltage | 3-phase 200V to 230V AC |
