To Next Page
R
ramirezrileySep 9, 2025
What to do if my Mitsubishi Electric Air Conditioner doesn't restart immediately?
- DDavid NealSep 9, 2025
Wait approximately three minutes before restarting. Operation has stopped to protect the air conditioner.
What to do if my Mitsubishi Electric Air Conditioner doesn't restart immediately?
Wait approximately three minutes before restarting. Operation has stopped to protect the air conditioner.
Why does my Mitsubishi Electric Air Conditioner stop on its own?
Your Mitsubishi Electric Air Conditioner might be stopping on its own because the off timer is set. In this case, press the ON/OFF button to restart operation. Also, the air conditioner could be connected to a central remote controller, or “ ” might appear in the remote controller display. If so, consult the concerned people who control the air conditioner.
Why does my Mitsubishi Electric Air Conditioner turn on by itself?
If your Mitsubishi Electric Air Conditioner is turning on without pressing the ON/OFF button, check if the on timer is set and press the ON/OFF button to stop operation. Also, the air conditioner could be connected to a central remote controller, or “ ” might appear in the remote controller display. Finally, the auto recovery feature from power failures might be set. In these cases, consult the concerned people who control the air conditioner or press the ON/OFF button to stop operation.
What to do if an error code appears on my Mitsubishi Electric Air Conditioner remote?
If an error code appears on your Mitsubishi Electric Air Conditioner remote controller display, it indicates that the protection devices have operated to protect the air conditioner. Do not attempt to repair this equipment by yourself. Turn off the power switch immediately and consult your dealer. Be sure to provide the dealer with the model name and information that appeared in the remote controller display.
Why is my Mitsubishi Electric Air Conditioner remote not working properly?
If nothing appears in the wireless remote controller display, the display is faint, or signals are not received by the indoor unit unless the remote controller is close, the batteries are likely low. Replace the batteries and press the Reset button. If nothing appears even after the batteries are replaced, make sure that the batteries are installed in the correct directions (+, –).
Why aren't the vanes moving or the indoor unit responding to the remote on my Mitsubishi Electric Air Conditioner?
The junction wire connectors of the vane motor and signal receiver may not be connected correctly. Have an installer check the connections. (The colors of the male and female sections of the junction wire connectors must match.)
Why do the vanes on my Mitsubishi Electric Air Conditioner move past the set position when changing airflow direction?
When the airflow direction is changed, the vanes move to the set position after detecting the base position.
Why do I hear water flowing or hissing sounds from my Mitsubishi Electric Air Conditioner?
These sounds can be heard when refrigerant is flowing in the air conditioner or when the refrigerant flow is changing.
Why does the airflow direction change on my Mitsubishi Electric Air Conditioner?
During heating mode, the vanes automatically move to the horizontal airflow direction when the airflow temperature is low or during defrosting mode.
Why does my Mitsubishi Electric Air Conditioner stop before reaching the set temperature in heating mode?
When the outdoor temperature is low and the humidity is high, frost may form on the outdoor unit. If this occurs, the outdoor unit performs a defrosting operation. Normal operation should begin after approximately 10 minutes.
General| Brand | Mitsubishi Electric |
|---|---|
| Model | Mr.SLIM PLA-M71EA |
| Category | Heat Pump |
| Language | English |
