182
8 FUNCTIONS
8.9 Firmware Update Function
Operation
■LED status
The firmware update status can be checked by the LED of the I/O module.
Error information list
The following table lists the error information of I/O module-specific errors that occur when a firmware update is performed.
If error information other than the above is displayed on the CC-Link IE TSN Firmware Update Tool, refer to the "Help" on the
CC-Link IE TSN Firmware Update Tool.
LED Normal
operation
Firmware update in progress Firmware update completed (completed successfully or
completed with an error)
RUN LED On Flashing Off
Error
information
Error name Description and cause Action
0001H File error A file that cannot be used for the update target I/O
module is specified.
Check the firmware update file specified by the
CC-Link IE TSN Firmware Update Tool.
After specifying a correct file, turn off and on the
power supply of the I/O module, and perform the
firmware update again.
0002H Communication error A communication error occurred during firmware
update.
• Check the Ethernet cable connection.
• Take measures against noise on the
transmission path.
After performing the above, turn off and on the
power supply of the I/O module, and perform the
firmware update again.
0003H Module error An error occurred in the module during firmware
update.
Turn off and on the module power supply, and
restart the CC-Link IE TSN Firmware Update
To o l.
If this error occurs again, the possible cause is a
module failure. Please consult your local
Mitsubishi representative.
0004H Firmware update failure The firmware update was performed while a data
link was in operation.
Perform the firmware update when a data link is
not performed (disconnected).
0010H Firmware version error A file of the firmware version that cannot be used
for updating the target I/O module is specified.
Check the firmware version of the firmware
update file specified by the CC-Link IE TSN
Firmware Update Tool.
After specifying a correct file, turn off and on the
power supply of the I/O module, and perform the
firmware update again.
To Next Page
Loading...
