What to do if the PW LED does not turn on in my Mitsubishi Electric Controller?
If the PW LED on your Mitsubishi Electric Controller doesn't turn on, it could be due to a hardware failure, in which case you should consult your local Mitsubishi representative. Alternatively, ensure that the module power supply (24VDC) is correctly wired and turned on. Also, verify that the voltage value is within the specified performance range.
What to do if the I/O PW LED does not turn on in my Mitsubishi Electric NZ2GF2S-60IOLD8?
If the I/O PW LED on your Mitsubishi Electric Controller is not turning on, make sure the external power supply (24VDC) is correctly wired and activated. Also, check that the voltage value is within the range of the performance specifications.
Why is the RUN LED not turning on in my Mitsubishi Electric Controller?
If the RUN LED is not turning on, the possible cause is a module failure, in that case please consult your local Mitsubishi representative. Also check that the module power supply voltage is within the range of performance specifications. After the check, power off and then on the module.
What does it mean when the MODE LED flashes on a Mitsubishi Electric NZ2GF2S-60IOLD8 Controller?
When the MODE LED flashes on your Mitsubishi Electric Controller, the IO-Link module is conducting a unit test. Take corrective action according to the result of the unit test.
General| Category | Controller |
|---|---|
| Manufacturer | Mitsubishi Electric |
| Model | NZ2GF2S-60IOLD8 |
| Voltage Rating | 24 VDC |
| Communication Interface | Ethernet |
| Type | Controller |
| Input Type | Digital |
| Output Type | Digital |
To Next Page