Mitsubishi Electric NZ2GF2S-60IOLD8 - IO-Link Module Parameter Setting

6 PARAMETER SETTING
6.2 IO-Link Module Parameter Setting
45
6
6.2 IO-Link Module Parameter Setting
This section describes the procedure for setting parameters of IO-Link module via the engineering tool.
Operating procedure
1. Open the "CC IE Field Configuration" window.
[Navigation window]  [Parameter]  [Module Information]  [RJ71GF11-T2]  [Basic Settings]  [Network
Configuration Settings]
2. Open the "Parameter Processing of Slave Station" window.
From the list of stations, select an IO-Link module  [CC IE Field Configuration]  [Online]  [Parameter Processing of
Slave Station].
3. Set "Method selection" to "Write Parameters".
4. Double-click the item to change the setting, and input the setting value.
Item Setting method
Items to input from the pull-down list Double-click the item to set, to display the pull-down list. Select the item.
Items to input from the text box Double-click the item to set, and input the setting value.
(1) Items to input from the drop-down list
(2) Checkbox
(3) The list cannot be collapsed.
(4) Items to input from the text box
(1)
(2)
(3)
(4)