Mitsubishi Electric NZ2GF2S-60IOLD8 - Chapter 1 Part Names

1 PART NAMES
13
1
1 PART NAMES
This section describes part names of the IO-Link module.
No. Name Application
(1) P1 PORT1 connector for CC-Link IE Field Network (RJ45 connector)
An Ethernet cable is connected. ( Page 37 Wiring of Ethernet cable)
L ER LED • On: Module received abnormal data, or module performing loopback
• Off: Module received normal data, or module not performing loopback
LINK LED Indicates the link status
• On: Link-up in progress
• Off: Link-down in progress
P2 PORT2 connector for CC-Link IE Field Network (RJ45 connector)
An Ethernet cable is connected. ( Page 37 Wiring of Ethernet cable)
L ER LED (Same as the LEDs of P1 connector)
LINK LED
(2) PW LED Indicates the power supply status of the IO-Link module.
• On: Power supply ON
• Off: Power supply OFF
RUN LED Indicates the operating status of the IO-Link module.
• On: Operating normally
• Off: A major error has occurred.
MODE LED Indicates the mode of the IO-Link module.
• On: Online mode
• Flashing: Unit test mode
• Off: In offline mode, or the unit test is completed.
D LINK LED Indicates the data link status of the IO-Link module.
• On: Data link in operation (cyclic transmission in progress)
• Flashing: Data link in operation (cyclic transmission stopped)
• Off: Data link not performed (disconnected or in unit test mode)
ERR. LED Indicates the error status of the IO-Link module.
• On: A moderate or major error has occurred.
• Flashing: A minor error has occurred.
• Off: Operating normally
When a major error has been occurred, check RUN LED as well.
(3) CH1 to CH8 LED (green) Indicates the operating status of each channel in IO-Link mode.
• On: Normal IO-Link communications
• Flashing: IO-Link communication error
*1
• Off: Other than IO-Link mode
CH1 to CH8 LED (yellow) Indicates on/off of input or output for each channel in SIO mode
• On: I/O is on.
• Off: I/O is off.
(4) CH1 to CH8 ERR. LED Indicates the error status of each channel in IO-Link mode or SIO mode.
• On: Channel error
• Off: Channels operating normally
(5) I/O PW LED Indicates the status of the power supply from the external power supply.
• On: External power supply ON
• Off: External power supply OFF
(6) Function setting switch A switch for the fast link-up function ( Page 30 Function setting switch setting)
(1) (2) (6) (7) (3)
(8) (10)(9) (9)
(4) (5)