192
APPX
Appendix 5 Processing Time
Appendix 5 Processing Time
Input response time
Input response time is the amount of time it takes from when input process data, CQ input signals, and DI signals are entered
into the IO-Link module until they are passed to cyclic transmission of CC-Link IE Field Network.
Input response time of input process data
The following is the calculation formula for the input response time of input process data.
Input response time = 125n + 2000 + m [s]
n: Process data length [bytes]
m: Cycle time [s]
Input response time of CQ input signal
The following is the calculation formula for the input response time of the CQ input signal.
Input response time = 2000 + 1000p [s]
p: Time set in the input response time setting (0, 1.0, 1.5, 5, 10, 20, 70ms)
Input response time of DI signal
The following shows the input response time of the DI signal.
Input response time = 110 + 1000p [s]
p: Time set in the input response time setting (0, 1.0, 1.5, 5, 10, 20, 70ms)
Output response time
Output response time is the amount of time it takes from when output process data and CQ output signals are passed to the
IO-Link module via cyclic transmission of CC-Link IE Field Network until they are output from the IO-Link module.
Output response time of output process data
The following is the calculation formula for the output response time of output process data.
Output response time = 125n + 1300 + m [s]
n: Process data length [bytes]
m: Cycle time [s]
Output response time of CQ output signal
The following shows the output response time of the CQ output signal.
Output response time = 1300 [s]
To Next Page
Loading...
