How to troubleshoot a Mitsubishi Electric Fan that does not turn on?
If your Mitsubishi Electric Fan isn't working, first ensure it's properly connected to a power source. Check the power plug (9/85-E models only), verify that the circuit breaker hasn't tripped, and confirm there isn't a power outage.
What to do if my Mitsubishi Electric vl-100u5-e is blowing less air than usual?
If your Mitsubishi Electric Fan is not providing the usual airflow, the outside or exhaust air filter might be clogged. Clean the filter to restore normal airflow.
What to do if the shutter on my Mitsubishi Electric vl-100u5-e is frozen?
If it's cold and the shutter on your Mitsubishi Electric Fan won't move, the outside air temperature, indoor air temperature, and humidity might have caused the shutter to freeze. Turn off the Lossnay until outside temperatures rise, and then resume operation.
Why is my Mitsubishi Electric vl-100u5-e so loud?
If your Mitsubishi Electric Fan is making more noise than usual, it could be due to a loose panel or outside air filter. Make sure the panel or filter is securely reattached. Also, a clogged outside or exhaust air filter can cause noise. Try cleaning the filter.
Why does the air from my Mitsubishi Electric vl-100u5-e Fan feel cold?
If the air from your Mitsubishi Electric Fan feels cold, it's likely due to a drop in the outside air temperature. You can temporarily turn off the unit and close the shutter, or adjust the louver direction as needed.
Why is there not much air coming from my Mitsubishi Electric Fan?
The Mitsubishi Electric Fan is designed as a heat-exchanging ventilator, so the airflow will be less than that of a regular fan, which is normal.
General| Brand | Mitsubishi Electric |
|---|---|
| Model | vl-100u5-e |
| Category | Fan |
| Language | English |
Severity of hazards from mishandling indicated by Warning (fatal/serious injury) and Caution (injury/damage).
Do not alter power cord to prevent fire or electric shock.
Do not operate if flammable gas is present to prevent explosion.
Do not touch power plug with wet hands; risk of electric shock.
Ensure power plug is fully inserted to prevent shock or fire.
Always shut off power before maintenance to avoid shock and burns.
Halt use immediately upon malfunction and contact dealer.
Position intake away from combustion gases to prevent oxygen depletion.
Do not place combustion equipment in unit's air path to prevent accidents.
Avoid hot areas, open flames, oily smoke, or solvents to prevent fire.
Never stick anything inside unit during operation; risk of injury.
Always grasp plug, not cord, when removing to prevent shock/fire.
Exchanges indoor and outdoor air, acting as a heat exchanger for ventilation.
Turn on circuit breaker and insert power plug into wall outlet.
Manually close shutter in adverse weather or during cleaning.
Use pull cord to switch between HI, LO, and Off operation modes.
Use control switches for power (On-Off) and airflow (Hi-Lo).
Clean exhaust and outside air filters at least once every six months.
Always shut off power before performing maintenance to prevent shock/burns.
Check power plug, breaker, or power failure.
Switch off power and contact dealer for strange sounds or no air output.
To Next Page
