Page 31
MODELS: WD-60C10 / WD-65C10 / WD-73C10 / WD-60638 / WD-65638 / WD-73638 /
WD-60738 / WD-65738 / WD-73738 / WD-82738 / WD-65838 / WD-73838 / WD-82838
SOUND PROJECTOR TRANSDUCER TEST (V43++)
This procedure will test will each of the TV’s speakers individually using an internal tone generator.
1. Press the <MENU> button on the remote control. The Customer Menu will appear.
2. Press the <2-4-5-7> buttons. The Service Menu will appear.
3. Press the <0> button. The Data Transfer & Geometry Menu will appear. See below.
4. Use the <TS> buttons to select “SOUND PROJECTOR TRANSDUCER TEST” and press <ENTER>. The
Sound Projector Transducer Test Menu will be displayed. A tone will automatically cycle from one
speaker to the next as indicated on screen. Follow the instructions to manually cycle the tone.
5. Press <EXIT> to exit.
Data Transfer & Geometry Menu <MENU><2-4-5-7><0>
RESTORE ENGINE DATA FROM BACKUP
RESTORE GEOMETRY DATA FROM BACKUP
MANUAL GEOMETRY ALIGNMENT
RESTORE INDEX DELAY
SAVE ENGINE AND GEOMETRY SETTING TO BACKUP
BACKUP AND RESTORE ISF SETTINGS
RED ONLY AND GREEN ONLY
SOUND PROJECTOR TRANSDUCER TEST
To Next Page
Loading...
Need help?
General
