App - 41
APPENDIX
Appendix 3.3.3 Precautions when utilizing sequence programs
When applying parameters and programs created for AnSCPU to AnSHCPU, follow the
procedures below.
The above procedures allow parameters and programs for AnSCPU to be used for
AnSHCPU without any change or modification.
Appendix 3.3.4 Checking the influence of the increased instruction processing speed on the system
Confirm the influences of the increased instruction processing speed and reduced scan
time on the user system.
(1) Select "Read File" from the initial setting menu after starting up the GPP function
software package.
(2) Read the parameter and program files created for AnSCPU from the floppy or hard
disk, and then write those parameters and programs into a peripheral device.
(This file reading operation is required for performing the procedure described in 3.)
(3) Using the PLC type change item in the initial setting menu, change the CPU type
name to A3 that is for AnSHCPU.
(Perform the procedure as given in 4, since the parameter is reset to the default.)
(4) Select the file maintenance menu to read the parameters and programs created for
AnSCPU from the floppy or hard disk into the peripheral device.
(Ignore the error message 'Unmatched PLC Type' even if such a message appers.)
To Next Page
Loading...
Need help?
General
