–75–
Outdoor LEV (SLEV) Coil Removal Procedure (configuration)
As shown in the figure, the outdoor LEV is made in such a way that the coils and the body can be separated.
<Removing the Coils>
Fasten the body tightly at the bottom (Part A in the figure) so
that the body will not move, then pull out the coils from the top.
If they catch on the stopper and are difficult to remove, turn
the coils left and right until the stoppers are free from the stop-
per indentations; then pull the coils out.
If you take out only the coils without gripping the body, undue
force will be applied to the piping and the pipe may be bent, so
be sure to fasten the body in such a way that it will not move.
<Installing the Coils>
Fasten the body tightly at the bottom (Part A in the figure) so
that the body will not move; then, insert the coils from the top,
inserting the coils’ stopper securely in one of the indentations
on the body. (There are four indentations for the stopper on
the body around its circumference, and any of the four inden-
tations may be used. However, be careful not to apply undue
force to the lead wires or twist them around inside the body.) If
the body is not gripped firmly when the coils are inserted, it
may exert undue force on the piping, causing it to bend. Be
sure to hold the body firmly and securely in place when install-
ing the coils.
Coils
Stopper
Lead Wires
Body
Indentation for
Stopper
(12 places around
the circumference)
Part A
Part A
To Next Page
Loading...
