–34–
4
GROUPING REGISTRATION OF INDOOR UNITS WITH M-NET REMOTE CONTROLLER
(1) Switch function
• The method used to register with a remote controller is shown below:
Registration/
ordinary mode
selector button
Registration/ordinary
mode selection button
Button to assign indoor
unit address
Registration button
Confirmation button
Delete button
Registered mode
selector button
Button to assign
interlocked unit address
A + B
C
D
E
F
G
H
This button is used to switch between ordinary mode and registered mode
(Ordinary mode is selected for the operation of indoor units)
* To select the registered mode, press and hold
FILTER
+
buttons for 2 seconds at stoppage.
[Note] The registered mode cannot be obtained for a while after power-
ing.
Pressing the
FILTER
+
buttons displays “CENTRALLY CON-
TROLLED”.
This button assigns the unit address to “INDOOR UNIT ADDRESS
NO.”
This button is used for group/interlocked registration.
This button is used to retrieve/identify the content of groups, interlock
(connection information), and registration.
This button is used to delete the content of groups, interlock
(connection information), and registrtion.
This button selects indoor units to register as groups (group setting mode)
or interlocked (interlocked setting mode).
* The unit address is shown at one spot for the group setting mode
while at two spots for the interlocked setting mode.
This button assigns the unit address of “OA UNIT ADDRESS NO.”
Symbol
of button
G Registered mode
selector button
E Confirmation switch
C Button to assign indoor
unit address
H Button to assign inter-
locked unit address
D Registration button
A
+
FILTER
TEST RUN
Name Symbols Description
of TEMP
of TIMER SET
CLOCK
→
ON
→
OFF
B
Registration/
ordinary mode
selector button
STAND BY
DEFROST
ERROR CODE
D A I L Y
AUTO OFF
CENTRALLY CONTROLLED
CLOCK
REMAINDER
ON OFF
˚C
1Hr
NOT AVAILABLE
˚C
CHECK MODE
FILTER
CHECK
TEST RUN
LIMIT TEMP.
ON/OFF
TEMP
FILTER
CHECK TEST
ON OFF
CLOCK
PAR-F27MEA
TIMER SET
F Delete button
To Next Page
Loading...
