Mitsubishi CP710E - Page 25

24
6. Printing procedures (Basic prints)
22
22
2 Continuous printing
The desired number of memorized images can be printed continuously when the desired number is set before printing.
The number of prints can be changed during printing. The continuous printing also can be cancelled by setting the number of
prints to 1 during printing.
Setting the number of prints
Press the PRINT Q'TY buttons , , to set the number of prints.
• Press
button to increase and button to decrease the number.
• The number of prints will be switched in the order of
1
2 .... 9 10 20 30 40 50 100 200 C 1
When "C" is selected, this unit continues printing until the print paper or ink sheet is used up.
• The set number of prints is displayed on the monitor screen.
* When "C" is selected, the number is not counted down.
Number
of prints
• During continuous printing, whenever one sheet is printed, the set
number is counted down.* The number is displayed on the monitor
screen.
• After the continuous printing is completed, the set value returns to "1".
Cancelling continuous printing
• When cancelling continuous printing:
A Cancelling after printing of an image is completed.
Press the PRINT Q'ty buttons
, , to set the number of prints to 1.
• After the image being printed is printed out correctly, the continuous printing is cancelled.
B Cancelling before printing of an image is completed
Press the STOP button on the remote control.
• The continuous printing is cancelled not completing the print, and the sheet comes out.
Changing the number of prints during printing
• When changing the number of prints during printing:
1 Press the PRINT Q'ty buttons
, , to set the number of prints to 1.
2 After the image being printed is printed out, press the PRINT Q'ty
, buttons, to change the number of prints.
Note :
• If blackish image is continuously printed, the internal temperature may rise and cause the unit to switch to a standby
condition during printing.
An error message "OVER HEAT" is displayed on monitor screen.
In this case, wait until the error message goes off.
Continuous printing resumes when the temperature drops and error message goes off.