Mitsubishi CP710E - Operation

58
8. Printing procedures (Special prints)
OPERATION
Setting the multi-print and photo-print menus
Setting multi-print and photo-print functions
1 Press the MENU button. Then, press the UP or DOWN shift button to select " 3. ADDITIONAL PUSH [ ] ".
2 Press the RIGHT shift button to select "3. ADDITIONAL".
3 Press the DOWN shift button to select " MULTI : OFF/ON". Then press the RIGHT shift button to select "ON " .
• " MODE : SAME/DIFF/PHOTO " is displayed on the menu screen.
• " IMAGES : 2/ 4/ 16 " is displayed on the lower line.
4 Set the multi-image type (2, 4 or 16) or photo print size.
• Set "MODE : SAME/DIFF/PHOTO" and "IMAGES : 2/4/16 or CARD/3*4/5*5/3*3.5" menus.
• Refer to 1 MULTI PRINT and 2 PHOTO PRINT for the multi-image type.
Setting the SEPARATE function
1 Press the DOWN shift button to select "SEPARATE : OFF/ON" .
2 Press the RIGHT shift button to select "ON".
Displaying the source image (image from the input signal) or the memorized image
1 Press the SET
SET
button.
• " CHANGE : OK/CANCEL " is selected.
• When changing the setting, select "CANCEL" and press the SET
SET
button.
2 Press the SET
SET
button.
• The MAIN MENU is displayed.
3 Press the SET
SET
button.
• "SAVE 1/2/3" is selected.
• This menu is used to store the setting in any one of 3 programs (1, 2 or 3).
4 Press the RIGHT
or LEFT shift button to select the program number 1, 2 or 3 to store the setting.
• The setting will be overlaid. When keeping the stored program, do not select the program No. in which the setting is
stored.