Mitsubishi CP710E - Page 60

59
8. Printing procedures (Special prints)
5 Press the SET
SET
button.
• The source image (image from the input signal) or memorized image is displayed.
Storing images in memory / Printing the images
1 Store the images to be printed in memory.
• Refer to 1 MULTI PRINT or 2 PHOTO PRINT for storing images in memory.
2 Press the PRINT button.
• The set SEPARATE images are printed.
Note :
• The distance between images in multi-print is different between on the monitor and the printed image.
• The image size changes according to the “SIZE” in “6. SYSTEM MENU”.
When the images of different size are memorized in one page, the margin is determined according to the largest width of
the image in the page.
44
44
4 STROBE PRINTS
OPERATION
Selecting FIELD or FRAME
Setting STROBE function.
1 Press the MENU button. Then press the UP or DOWN shift button to select “3.ADDITIONAL PUSH[ ]”.
2 Press the RIGHT shift button to select “3. ADDITIONAL”.
3 Press the UP shift button to select “STROBE : OFF”.
4 Press the RIGHT shift button to select “STROBE : 1/6 .... 1hr”.
• Each time the RIGHT or LEFT shift button is pressed, the interval of image memorization is switched.
• 1/6 sec • 1/3 sec • 1 sec • 2 sec • 5 sec • 10 sec • 30 sec .............................................................................. every second
• 1 min • 2 min • 5 min • 10 min • 30 min............................................................................................................ every minute
• 1hr .......................................................................................................................................................................every hour
• Images can not be memorized during printing.
The interval of memorization may be a littel vaied.