Mitsubishi CP710E - Page 52

51
8. Printing procedures (Special prints)
3 Press the DOWN or UP shift button to select "MULTI : OFF/ON ". Then, press the RIGHT shift button to
select "ON".
• "MODE : SAME/DIFF/PHOTO " is displayed on the menu screen.
• "IMAGES : 2/ 4/ 16 " is displayed on the lower line.
4 Press the DOWN shift button to select " MODE : SAME/DIFF/PHOTO ". Then, press the RIGHT shift button to
select SAME " or " DIFF ".
• When " SAME " is selected, a multi-image (2, 4 or 16 images) of the same image can be printed.
• When " DIFF" is selected, a multi-image (2, 4 or 16 images) of the different images can be printed.
5 Press the DOWN shift button to select "IMAGES : 2/4/16". Then press the RIGHT shift button to select 2, 4 or 16.
• The multi-image setting is completed.
• When "2" is selected, 2 images can be stored in memory.
• When "4" is selected, 4 images can be stored in memory.
• When "16" is selected, 16 images can be stored in memory.
Displaying the image from input signal (source image) or the memorized image
1 Press the SET
SET
button.
• " CHANGE : OK/CANCEL " is selected.
• When changing the multi-print function, select "CANCEL" and then press the SET
SET
button.
2 Press the SET
SET
button.
• The MAIN MENU is displayed.
3 Press the SET
SET
button.
• "SAVE 1/2/3" is selected.
• This menu is used to store the setting in any one of 3 programs (1, 2 or 3).
4 Press the RIGHT
or LEFT shift button to select the program number 1, 2 or 3 to store the setting.
• The setting will be overlaid. When keeping the stored program, do not select the program No. in which the setting is
stored.
5 Press the SET
SET
button.
• The source image (image from the input signal) or memorized image is displayed.