Mitsubishi CP710E - Troubleshooting and Maintenance; Error Messages and Solutions

66
8. Printing procedures (Special prints)
Circuit inside the VCP
VCP
Pin No.
66
66
6 REMOTE terminal
By sending the following remote control codes from Pin No. 6, the same functions as the wired remote control
(accessory) can be controlled.
Code Function Code Function
01 LEFT SHIFT button 02 RIGHT SHIFT button
03 DOWN SHIFT button 04 UP SHIFT button
08 PRINT Q'ty button (increase) 09
0A* MENU button 0B* CLEAR button
0C PRINT Q'ty button(decrease) 0D
0E* SET button 0F* STOP button
12* PROG. (Program) button 13* PRINT button
15* FIELD/FRAME button 16* COLOR ADJUST button
17* MEMORY button 18* DISPLAY button
1C* MEMORY PAGE button 1D* MONITOR button
In case of the codes with * mark, 5 words are sent.
TIMING CHART
Input signal level : TTL
Input timing : 1 word 38.4 ms
Example : print code = 13=010011
1K
To VCP
2 MEMORY
/ PHOTO mode input
6 REMOTE
User side
5 PRINT
CMOS
CMOS
DC5V
To VCP
10KΩ
1KΩ
100Ω
DC5V
To VCP
From VCP
DTC124EK
3 BUSY2
From VCP
22KΩ
DTC124EK
22KΩ
4 BUSY1
1KΩ
10KΩ
100Ω
DC5V
10KΩ
100Ω
22KΩ
22KΩ
DC5V
10KΩ
100Ω
1.6 ms
0.4 ms
Input timing : Code : " 0 "
3.2 ms
0.4 ms
Input timing : Code : " 1 "
110010