69
9. Troubleshooting
Before calling for service
Symptom
No power
No image appears on the monitor.
The image is not stored in memory.
The image is not printed.
Check and Remedy
Is the power cord plug disconnected form the outlet?
Connect the power cord plug to the outlet firmly.
After turning the power off, wait for approx. 2 minutes.
Then turn the power ON.
Are the video signal and sync. signal inputted to this unit?
Check the connection. Refer to pages 9-10.
Is the input signal on the menu screen (INPUT : VIDEO, S-VIDEO)
selected correctly?
Check the current setting. Refer to page 33.
Is the image stored in memory displayed on the monitor screen?
Press the MONITOR button to display the source image (LIVE).
Are the images being printed?
Store image in memory after completing printing.
Press the CLEAR button on the remote control after printing.
Then, store the image in the memory again.
Is the memory full in the status of “MEM&STOP : ON”?
Store the image in the memory after pressing the CLEAR button on
the remote control.
(Depending on the setting conditions, the image can be stored in
the memory by setting “MEM&STOP” to “OFF” or pressing the
PRINT button.)
Is the image stored in memory?
Confirm that the image is stored in memory.
Is the print paper or ink sheet used up?
Check the status.
Is the printing unit set correctly?
Set the printing unit correctly.
To Next Page
Loading...
