Remote control buttons and functions (cont.)
(_ quick program button (QUICK PROGRAM)
Use this button to perform autoraated prol_amming operations
with both your TV and your Mitsubishi "VCR. When you press
this button, your TV will switch to the External-1 input, your
VCR will turn on, and the VCR's "Program to record" mem_ will
appear. When you are finished prograraming your VCR, press
this button again; your VCR will turn off, and your TV will
return to its previous position.
If you press this button while the TV is locked, or while using
the television's menus, then the VCR will turn on, but the TV
will not switch inputs.
Additionally, you must have connected your VCR with the A!V
Network.
_nurnber buttons (0-9)
Use to select a channel nuraber, and to enter the parental lock
code.
(_ off-timer button (OFF-T)
Use to program the TV to turn off automatically at a later time.
(_ picture-in-picture controls
Use to control the special picture-in-picture (PIP) function.
• PIP button (PIP)---Press to see the reduced PIP image or
cancel it. See "Using the Actiw_ A/V Network Feature," page 91.
• channel button (CHANNEL)--Press to change the channel of
the reduced PIP image.
• source button (SOURCE)---Press repeatedly to switch the
source of the reduced PIP image between the TV and the exter-
nal inputs.
• pause button (PAUSE)---Press to freeze the reduced. PIP
image or cancel the image freezing. Ai[so use for the adwLnced
PIP functions.
• enter button (ENTER)---Press to switch back and forth be-
tween the reduced PIP image aad the main image.
• adjust up/down buttons, right/left buttons---Press to move
the position of the reduced PIP image.
24 Chapter 1 : Getting to Know Your [1_
To Next Page
Loading...
Need help?
General
