Adding and deleting channels
Either "In memory" or
"Not in memory" will
appear.
After all available channels have been programmed automatically,
channels with weaker signals can be added or deleted by using the
following procedure.
First Time Set-Up
Set the clock
Memorize channels
Ib Addidelete channels
Set AN Network
Use ADJUST to select.
Then press ENTER.
Press MENU to return to
TV Main Menu.
O Press the MENU button on the
remote control. The TV Main
Menu will appear on the screen.
O Select "First Time Set-Up" using
the ADJUST button; then press
the ENTER button.
Select "Add/delete channels"
using the ADJUST button; then
9ress the :ENTER button.
A_d/delete channels
Antenna Ant-A
Channel 006
In memory
Use ADJUST to select
another channel.
Press CANCEL to delete.
Press MENU to return to
First Time Set-Up Menu.
O The "Add/delete channels" screen
will appear.
Select the channel you would like
to add or delete using the AD-
JUST button; then press the
ENTER or CANCEL button.
Channels that are in memory
have the word "In menmry";
channels not in memory say "Not
in memory."
O
Following tbe additional on-
screen in,_tructions, add a chan-
nel into channel memory or
delete a channel from channel
memory..
DImportant: Only in this menu screen, the CHANNEL _, button changes to a
channel with a higher number one by one; the CHANNEL •
button changes to a channel with a lower number one by one.
You may switch between the antennas (Antenna A and $mtenna B)
by pressing the input button (INPUT).
Getting Started 61
To Next Page
Loading...
Need help?
General
