Using the Active AN Network Feature
This A/V Network is a special feature that makes it easier to use
your television and your other A/V components together. When
you connect the A/V Network, you can point the remote conLrol at
the television, and it will "pass" the remote control command to the
other components.
Additionally, you will gain even more benefits if you have a
Mitsubishi VCR equipped for the Active A!V Network. The Active
A/V Network allows you to perform ruany of the commonly used
features of your system at the press of just one button.
This section will explain the various features of the Active A/V
Network.
before you begin
You must have connected an A/V Network cable from the
Active A/V Network terminal of your TV to the A/V Network IN
terminal of your VCR. See "TV+Mitsubishi products that have
A/V Network terminals", page 43.
• You must have connected your VCR to External 1 (EXT-1) of
your TV.
• You must have set your TV's "A/V Network" setting to "Active"
or "Basic". See "Setting the A/V Network," page 62.
Your VCR's remote control switch (if an)') should be set to
"VCR-A".
Your VCR's _ideo mute setting should be turned ON.
_>Important:
what the Active A/V Network does
The Active A/V Network makes it easier_and faster to use 1;he
VCR's Quick Program and Play commands and the TV's P][P com-
mands.
When using the Active A/V Network, you should always point your
remote control at your television.
Using the Active A/V Network Features 91
To Next Page
Loading...
Need help?
General
