Using the remote control
[;>Important:
operating Mitsubishi components
This remote control unit comes programmed to operate Mitsubishi
TVs, VCRs and audio components. The select buttons determine
which component the remote control will operate.
The following buttons are available when operating this TV set..
I
power button
pause button
mute control
super quick view button
quick view button
volume control
input button
channel control
enter button
audio and video controls
Q
menu button
c.ancel button
€tisplay button
home button
off-timer button
number buttom_
PIP controls
PI_Y button
quick program button
operating VCRs from other manufacturers or cable box
The remote control is pre-set te operate Mitsubishi VCRs, but :it can
also operate VCRs from other manufacturers .as well. If you have a
VCR from another manufacturer, or if you have a cable box, it is
advisable to set up the remote control.
Each layer (CABLE, VCR-A or VCR-B) can be set for either a cable
box or a VCR.
<setting up the remote control to operate your VCR>
ID Turn offyour VCR.
Choose the layer using the select, button on the remote control:
VCR-A, VCR-B or CABLE.
O
While holding in the POWER button on the remote control
enter the code number listed in the chart on the following page
fbr your brand of VCR. Be sure to enter both digits of the code
number. (If more than one code number is listed, try the first
one. If that code does not work, try the next one until :you find
the correct code.)
Release the POWER button.
Press the POWER button again. Your VCR should turn on. If
the VCR turns on, your remote control is now set to operate your
VCR.
If your VCR does not turn on, repeat the instructions, trying each
code number listed for your brand of VCR.
48 Chapter 3: Operating Your TV
To Next Page
Loading...
Need help?
General
