Using the active A/V Network (cont.)
using the quick program button (QUICK PROGRAM)
When you press QUICK PROGRAM to begin programming your
VCR:
• Active A/V Network will turn on your VCR and bring it to the
"Program to Record" screen. (If the VCR's clock ha,_ not been
set, you will see the "Set the clock" screen See your VCR's
Owner's Guide for information about setting the clock.)
• Active A/V Network will turn on your _I_ (if it is off), and switch
the TV to EXT-1.
You can program your VCR by pointing your remote control at the
TV.
When you press QUICK PROGRAM to end programming your
VCR:
• Active A/V Network will turn off your VCR (unless a tape is
currently playing or recording).
• Active A/V Network will return your TV to the channel it was
on before, or turn it off (if it was off originally).
using the PLAY button (AUTO PLAY)
When you press PLAY on the remote:
• Active A/V Network will turn your VCR on and begin playing
the tape (if any).
• Active A/V Network will turn your TV on and switch it to EXT-1.
When you turn your TV off:
• Your VCR will turn off, unless it is playing or recording.
_>Important:
using the PIP button (TWO TUNER PIP)
You must be watching a broadcast channel on Antenna-A or An-
tenna-B to use the Active A/V Network PIP function correctly.
When you press the PIP button on the renmte to bring up a PIP
image:
• Your VCR will automatically turn on.
• You can see the VCR's picture in the small PIP image.
While the PIP image is on the screen:
• The PIP fhnction buttons (SOURCE, CHANNEL, ENTER, right/
left, adjust up/down, PAUSE) will all work in the same manner.
92 Chapter 4 : Using the Special Features
To Next Page
Loading...
Need help?
General
