• The CHANNEL and number buttons (0-9) will automatically
control the small PIP image. You cannot change channels on
the main image.
When you press the PIP button on the remote to turn off the PIP
image:
• CHANNEL, the number buttons, and all other functions will
work normally again.
_>Important-
L>Important:
If you turn offthe TV while it is set to EXT-1, it will return to the
last channel you viewed on Antenna-A or Antenna-B when you
turn the TV back on.
If you leave the TV turned on, set to EXT-1, but the TV is not
receiving a signal on EXT-1, it will automatically turn off after five
minutes. (If you use a TV menu during this time, the TV will turn
off five minutes after you stop using the menus.)
_>Important:
You should not press the PIP button while you are watching a
channel that is not receiving any broadcasts. YOU will not be able
to see the small PIP image, and you will not be able to change
channels on the main image. You may need r,o turn off the _YVand
turn it back on, change to a channel that is receLving a broadcast,
and begin again.
Using the Active A/V Network Features 93
To Next Page
Loading...
Need help?
General
