TV+Mitsubishi products that have A/V Network
terminals
The A/V Network is a special system that Mitsubishi developed to
make it easier to use the remote control. When the supplied cable
is connected between two Mitsubishi products with the A/V Net-
work, you can point the remote control at one. product and it will
"pass" the remote control command to the other.
equipment you will need
• 1 A/V network cable
(included with the TV).
Procedure
O Connect one end of an A/V network cable to the ACTIVE A/V
NETWORK terminal on the back of the TV.
O Connect the other end of this cable to the A/V NETWORK IN
terminal on the back of a Mitsubishi component that has tffV
network terminals.
You can now point your component remote (such as a VCR
remote) directly at the television. The A/V cable will "pass" the
remote commands to the component.
[>Important: The method of connecting the A/V network can change, depending
on which components you have and the way you plan to use your
equipment. More detailed information is contained in the owner's
guide of each particular Mitsubishi component.
Basic Connections 43
To Next Page
Loading...
Need help?
General
