3-166
Features and controls
3
PHONE button
● Press this button when an incoming call is received to
answer the telephone.
● When another call is received during a call, press this but-
ton to put the first caller on hold and talk to the new caller.
• In such circumstances, you can press the button briefly
to switch between callers. You will switch to the first
caller and the other caller will be put on hold.
• To establish a three-way call in such situations, press the
SPEECH button to enter voice recognition mode and
then say “Join Calls.”
● Press and hold this button when an incoming call is
received to refuse the call.
● Press and hold this button during a call to end the current
call.
When another call is on hold or there is an incoming call,
you will switch to that call.
SPEECH button
● Press this button to change to voice recognition mode.
● If you press the button briefly while in voice recognition
mode it, will interrupt prompting and allow voice com-
mand input.
Pressing the button longer will exit the voice recognition
mode.
● Pressing this button briefly during a call will enable voice
recognition and allow voice command input.
OTE
● When you press the SPEECH button to enter voice recog-
nition mode with a cellular phone paired to the system,
current information on the cellular phone, such as
“remaining battery life,” “signal strength” or “roaming,”
will be displayed on the audio display.* (Refer to “Pairing
a cellular phone” on page 3-172.)
*: Some cellular phones will not send this information to
the Bluetooth
®
HFP.
● Call waiting and three-way calls can be used by the Blue-
tooth
®
HFP, only when those services can be used with
your cellular phone.
● Users may experience a delay in vehicle audio when plac-
ing a call from the handset. Users may experience a delay
in vehicle audio when answering an incoming call on the
handset. To reduce delays users should place calls and
receive calls through the Hands-free System.
BK0121600US.book 166 ページ 2010年4月12日 月曜日 午前10時39分