2.
NOMENCLATURE AND FUNCTIONS
Installing the parameter unit using
a
cabb
(1)
Connection
Assemble one end of the connector
to
the inverter
and other end to the parameter unit. Use the guide
pin and guide
slot
to
determine the correct connector
orientation.
(Forcing the connectors together in Wsition
to
the
polarizing guides
will
damage the inverter.)
(2)
Fixing
Align
me
guide
pin
After connecting the connector to the inverter unit,
with
me
guide
slot.
securely
fix
It
with the mounting
screws.
~ ~~~~~
Note:
Use
the connection cable available as an optional accessory
to
the parameter unit.
I1
It
is necessary to securely
fix
the
cable
to
tb
parameter
unit,
use
the
L-pattern
cable.
Removing and Attaching the
Paremeter
Unit Cover
I
I
(1)
Open the parameter unit cover
90'
While pressing to the right against the hinge
(1)
at
the thumb lightly pressing on the lug
(2),
at
the upper left
of
the cover, pull the cover with
the upper right
of
the
cover.
I
(2)
Pull
the parameter unit cover to the left
to
remove it
from the parameter unit.
Adjust the parameter unit cover position
so
that the
slot faces
in
the direction as illustrated
in
the left.
when the
slots
are
set
in this position.
The parameter unit cover can
be
removed only
r
Note:
When attaching the parameter una cover,
set
the
slots in
the
cover in
the
direction
as
illustrated and
push to the right.
To Next Page
Loading...
