11.
OPERATION
11.6
Switch
over
mode
With this mode, the external operation
rode,
PU
operation
mode
and
computer
link operation
modes
can
be
entered while the inverter
is
running.
The
(OHOwing
mcde
transNm
func(ions are vscd dwinp
the
Wh
over
rode.
~~
Operation mode
trahsaion
Transition operatidoperation state
External
operation
PU
operation
8
External
operation
computer
link
wration
4
0
Press
the
PU operation key.
The rotation
dLection
will
antie
to
be
that appked during external
The
set
frequency
will
continue
to
be
the
value
set
with
the
vaM
operation.
resistor (frequency setter). (Note that
once
the
power
is
turned
OFF or
inverter is
reset.
mat
set
value
will
be
cleamd.)
@
Remove
the
parameter unit, and install
the
computer link unit FR-CU03
0
Transmit the command to change
to
the computer link mode from the
(option).
computer.
The
rotation
dirsdion
will
continue
to
be
that
applied
during external
The
set
frequency
will
mnenue to
be
the
vakre set with the variable
operation.
resistor (frequeocy setter).
(Nde
that
once
the
power
is
turned OFF or
inverter
is
reset
that
set
value will
be
cleared.)
PU
operation
External operation
4
PU
operation
Comprter
Link
operation
4
Computer link
operation
External owration
4
0
Press
the
external operation key on the parameter unit.
The rotation direction
will
be
decided by
the
external operation input
The set frequency
will
be
decided by the external frequency setting
signal.
signal.
0
Remove the parameter unit, and install
the
computer link unit FR-CUO3
(optW.
Transmit
the
command
to
change
lo the cwnputer link mode from
the
computer.
.
The rotation direction and setting frequency
will
continue in the PU
operation state.
0
Remove the computer
link
unit FFI-CUO3 (option), and install
the
@
Press
the
external
operebon
key
on
the parameter unrt.
parameter unit
The rotation direction
will
be
decidnd by
the
external operation input
The
set
frequancy
will
be
decided by the external frequency setting
signal.
siand.
0
Remove the computer link unit FR-CUO3 (option), and install the
Computer link
operation
parameter unit.
1
0
Press
the
PU operation key on
the
parameter unit.
PU operation
-
The rotation direction and setting frequency
will
continue in
the
computer link operation state.
3
w'
i
-34-
To Next Page
Loading...
