Mitsubishi FX1N-40MT-DSS User Manual

FX1N Series Programmable Controllers Introduction 1.
1-13
1
2
3
4
5
6
7
1.4.2 Note for Using Expansion Board
The following conditions cannot be accomplished with an FX
1S
PLC.
-FX
1N
-422-BD + FX-2PIF
-FX
1N
-5DM + FX
1N
-422-BD + FX-10DM
-FX-10DM + FX
1N
-422-BD + FX-10DM
- Connect two Programming tools (FX-10P-E, FX-20P-E, Programming software, etc.)
- The use of Special function Blocks
Caution
Connect a programming tool (such as an FX-10P-E, FX-20P-E and personal computer) to
either the connector built in to the PLC or the connector on the FX
1N
-422-BD or FX
1N
-232-
BD. If a programming tool is connected to both connectors, the program stored in the PLC
may not match the program stored in the programming tool. If the program is changed or the
set value of timers or counters are changed with this configuration, the program may be par-
tially overwritten and the PLC may malfunction.

Mitsubishi FX1N-40MT-DSS Specifications

General

Brand	Mitsubishi
Model	FX1N-40MT-DSS
Category	Controller
Language	English