Mitsubishi i-MiEV 2017 - Page 167

Bluetooth® 2.0 interface (if so equipped)
5-58 Features and controls
5
If a passcode has been set and the security
function is enabled, the voice guide will say
“Hands-free system is locked. State the pass-
code to continue” when the PICK-UP button
is pressed to enter voice recognition mode.
Say the 4-digit passcode number to enter the
passcode.
If the entered passcode is wrong, the voice
guide will say “<4-digit passcode>, Incorrect
passcode. Please try again.” Enter the correct
passcode.
Use the following procedure to turn off the
security function by disabling the passcode.
1. Press the PICK-UP button.
2. Say “Setup.”
3. Say “Passcode.”
4. The voice guide will say “Passcode is
enabled. Would you like to disable it?”
Answer “Yes.”
Answer “No” to cancel the disabling of
the passcode and return to the main menu.
5. When the disabling of the passcode is
completed, the voice guide will say “Pass-
code is disabled” and the system will
return to the main menu.
N00564700011
The Bluetooth
®
2.0 interface can use the
speaker enrollment function to create a voice
model for one person per language.
This makes it easier for the Bluetooth
®
2.0
interface to recognise voice commands said
by you.
You can turn a voice model registered with
the speaker enrollment function on and off
whenever you want.
N00564801149
It takes about 2 to 3 minutes to complete the
speaker enrollment process.
To ensure the best results, run through the
process while in the driver’s seat, in an envi-
ronment that is as quiet as possible (when
there is no rain or strong winds and the vehi-
cle windows are closed). Please turn off your
phone while in speaker enrollment to prevent
interruption of the process.
Use the following procedure for speaker
enrollment.
1. Stop your vehicle in a safe area, put the
selector lever in the “P” (PARK) position,
and then pull the parking brake lever.
2. Press the PICK-UP button.
3. Say “Voice training.”
4. The voice guide will say “This operation
must be performed in a quiet environment
while the vehicle is stopped. See the
owner’s manual for the list of required
training phrases. Press and release the
SPEECH button when you are ready to
begin. Press the HANG-UP button to can-
cel at any time.”
Press the SPEECH button to start the
speaker enrollment process.
Entering the passcode
NOTE
 You can reenter the passcode as many times
as you want.
 If you have forgotten your passcode, say
“Cancel” to quit the voice input mode and
then check with a certified i-MiEV dealer.
Disabling the passcode
NOTE
 System must be unlocked to disable the pass-
code.
Speaker enrollment function
Speaker enrollment
NOTE
 Speaker enrollment is not possible unless the
vehicle is parked. Make sure you park the
vehicle in a safe area before attempting
speaker enrollment.
BK0233400US.book 58 ページ ２０１５年１１月１６日 月曜日 午前７時４０分