Mitsubishi i-MiEV 2017 - Page 273

Replacement of light bulbs
9-26 Vehicle care and maintenance
9
3. Move the light unit toward the rear of the
vehicle and remove the pins (B) of the
light unit from the vehicle.
4. Turn the socket counterclockwise to
remove it.
5. Pull the bulb out of the socket.
6. To install the bulb, perform the removal
steps in reverse.
N00935400108
1. Remove the clips (A), then lift the cover
(B).
2. Turn the socket (C) counterclockwise to
remove it.
C- Tail and stop light (LED) - cannot be
replaced
D- Rear turn signal light
E- Back up light
NOTE
 The tail and stop lights use LEDs rather than
bulbs.
For repair and replacement, contact a certi-
fied i-MiEV dealer.
Rear side-marker lights
BK0233400US.book 26 ページ ２０１５年１１月１６日 月曜日 午前７時４０分