HOW TO USE THIS MANUAL
Description
This manual explains how to use “removal, installation, disassembly,
assembly, inspection and adjustment” and “diagnosis.”
Definition of Terms
WARNING: Instructions and precautions that may lead to fatal
hazards and/or serious injuries if not observed properly.
CAUTION: Instructions and precautions that require special
attention and may lead to problems and/or accidents as
well as damages to the vehicle and/or components.
NOTE: Provides additional information that facilitates
operation.
Standard: Indicates tolerances for inspection and adjustment.
Repair limit: Indicates maximum or minimum values allowed for
inspection and adjustment.
Definition of Units
The units and numerical values in this Standard are SI units, and
those given in ( ) in this Standard are based on the conventional unit
system and are appended for informative reference.
Example: Tightening torque 59 - 78 N·m (6.0 - 8.0 kgf-m)
SI (Metric system)
Main unit changes
* The conventional unit can be used for SI.
Description
Caution: At the beginning of each section, the precautions
exclusive to the section are described.
Preparation: At the beginning of each section and during the trouble
diagnosis items, the Special Tools (STs), gauges, and
other tools to be prepared before operation are
described. Some commercial service tools, assumed to
be available in any workshop, are omitted.
Description: To perform correct operations, operational procedures,
notes, STs, and other service information are
described.
CAUTION: Descriptions of visual inspections and cleaning of
removed parts are generally omitted. Please remember
that actual operations require these processes.
Measure SI Conventional unit Conversion factor to SI
Acceleration
m/s
2
G 9.80665
Torque, moment N•m kgf-m 9.80665
Force N kgf 9.80665
Pressure MPa
kgf/cm
2
0.0980665
kPa mmHg 0.133322
Power efficiency kW PS 0.735499
W kcal/h 1.16279
Volume
cm
3
cc 1
Spring constant N/mm kgf/mm 9.80665
Fuel consumption *g/kW•h g/PS•h 1.3596
GI-2
HOW TO USE THIS MANUAL
To Next Page
Loading...
Need help?
General
