Correct Operation
• Make sure that you understand the symptoms before starting
trouble diagnosis.
• Check correct installation status prior to removal or
disassembly. Make sure that they do not interfere with the
function of the parts they are applied to if matching marks are
required.
• Once they are removed, always replace parts indicated as “do
not reuse” with new ones. This includes: oil seals, gaskets,
packings, O-rings, lock washers, cotter pins, and self-locking
nuts.
• Replace inner and outer races of tapered or needle roller
bearings as a set.
• Arrange disassembled parts in order and prevent them from
being mixed-up.
• Clean or flush disassembled parts prior to inspection or
assembly.
• Use Genuine MITSUBISHI parts for replacement.
• Use authorized grease and sealer.
• Release the pressure before disconnecting pressurized piping
or hoses.
• Be sure to check for leakage after repairing fuel, oil, coolant,
exhaust, or vacuum systems.
Precautions for Radio Equipment Installation
Check the following when installing a commercial/ham radio or
mobile phone. If mounting position is not chosen carefully, the unit
may interfere with the electric control system.
• Separate the antenna as far from the Engine Control System as
possible.
• Route an antenna feeder line at least 20 cm apart from the
control unit harness.
• Adjust antenna and feeder line to eliminate radio wave
interference.
GI-4
PRECAUTIONS FOR SAFETY AND QUALITY
To Next Page
Loading...
Need help?
General
