Mitsubishi KXZ Series - Page 288

-
286
-
'20 • KX-T-373
Precauons for safety
●
Read these "Precauons for safety" carefully before starng disassembly work and do it in the proper way.
●
When disassembling, be sure to turn off the power. When disassembling the electrical components, check the electrical wiring diagram.
●
The electrical components are under high voltage by the operaon of the booster capacitor.
Fully discharge the capacitor before commencing a repair work. Failure to observe this warning could result in electric shock.
●
When parts of refrigerant cycle is disassembled by welding, be sure to work aer collecng a refrigerant, if the refrigerant isn't
collected, the unit might explode.
●
Be sure to collect refrigerant without spreading it in the air.
●
These contents are an example. Please refer to a similar part of actual unit.
1.
To remove the lid of control box
(1) Remove 2 lid fixing screws then remove
the lid.
2.
To remove the printed circuit board (PCB)
(1) Remove the lid of control box.(See No.1)
(2) Pull off all the inserted connectors.
(3) Take off 6 fixing hooks then remove
the PCB.
3.
To remove the impeller and motor (FM)
(1)
Remove 4 bellmouth fixing screws then remove the bellmouth.(
○
mark)
(2)
Remove the turbo fan fixing nut then remove the turbo fan.(
□
mark)
(3)
Remove 2 plate fixing screws then remove the plate.(
←
mark)
(4)
Disconnect the motor connector(CNMx) in the middle of wiring.
(5)
Remove 3 motor fixing nuts then remove the motor.(
△
mark)
4.
To remove the drain pan
5.
To remove drain pump (DM) and float switch (FS)
(1) Remove the lid of control box.(See No.1) (1) Remove the lid of control box.(See No.1)
(2) Remove the plate fixing screw then remove (2) Disconnect the drain pump connector(CNRx) and
the plate.(
○
mark)
float switch connector(CNIx).
(3) Remove the sensor holder screw then remove (3) Remove the drain pan.(See No.4)
the sensor holder.(
□
mark)
(4) Pull the hose to the arrow direcon then remove the hose.
(4) Remove 4 drain pan fixing screws then remove (5) Remove 3 drain pump fixing screws then remove
the drain pan.(
←
mark) the drain pump.(
○
mark)
(6) Remove the float switch fixing screw then remove
the float switch.(
□
mark)
PJA012D792A
DISASSEMBLY PROCEDURE
PROCEDURE & PICTURES
(FDTC series)
① ②
③
(2) FDTC series
PJA012D792A