Mitsubishi KXZ Series - Page 335

-
333
-
'20 • KX-T-373
Option (B)
▶
screws.
①
Remove the screw at the side of the motion sensor and slide the upper case in the direction of the arrow.
(The same as
②
of Option (A))
②
Pull the wiring of the motion sensor toward the side. Cut off the thinner part of the upper case.
③
in 2 locations of the installing holes (4 locations) with the
attached screws. (The same as
⑤
of Option (A))
④
Using a crimping terminal, etc., connect the same color to
the relay wiring (prepare on site) and the wiring of motion
sensor.
(The same as
⑥
of Option (A))
⑤
Taking care not to pinch the wirings, slip the upper case
into the lower case, and tighten the screws.
(The same as
⑨
of Option (A))
⑥
Seal the cut part at Step
②
with putty.
Option (C)
①
Set up the switch box and
relay wiring (prepare on site) in
advance.
Seal the relay wiring inlet with
putty.
Lower case
Upper case
Thinner part
φ15 hole (ceiling hole)
for passing through the wiring
φ15 hole
(ceiling hole)
for passing
through the wiring
Switch box Switch box
Conduit pipe
(prepare on site)
Seal with putty
Wall
Lock nut
( prepare on site)
Switch box
(prepare
on site)
Bushing
(prepare on site)
Switch box
(prepare on site)
Relay wiring
(prepare on site)
Positional relation for the switch box and installing holes