LUBRICATION SYSTEM
9-8
3.2 Installing oil filter, relief valve and oil pressure
Installing oil filter, relief valve and oil pressure
3.2.1 Installing oil pressure switch
&$87,21
Do not allow sealant to squeeze out at the thread end.
Do not overtighten.
(1) Using an oil pressure switch socket wrench, tighten the
oil pressure switch to the specified torque.
(2) Apply a sealant to the threaded portion when installing
the switch.
Installing oil pressure switch
3.2.2 Installing relief valve
Insert the relief plunger and relief spring into the gear case
and tighten the plug to the specified torque.
Installing relief valve
39.2 to 49.0 N㨯m
{4.0 to 5.0 kgf㨯m}
[29 to 36 lbf㨯ft]
7.85 to 11.8 N㨯m
{0.8 to 1.2 kgf㨯m}
[5.8 to 8.7 lbf㨯ft]
Oil pressure switch
socket wrench
P/N:MD998054
7.85 to11.8 N·m
{0.8 to 1.2 kgf·m}
[5.8 to 8.7 lbf·ft]
Apply HERME SEAL H1 or
THREEBOND 1344N.
Plug
Relief spring
Gear case
Relief plunger
39.2 to 49.0 N㨯m
{4.0 to 5.0 kgf㨯m}
[28.9 to 36.2 lbf㨯ft]
To Next Page
Loading...
