INSPECTION AND REPAIR OF BASIC ENGINE
6-18
4.10 Measuring crankshaft runout
Support the crankshaft at the front and rear journals with V-
blocks, and measure the crankshaft runout at the center
journal using a dial gauge. If the runout deviates from the
standard only slightly, grind the crankshaft to repair. If the
runout exceeds the standard considerably, straighten the
crankshaft using a press.
If the limit is exceeded, replace the crankshaft.
If the crankshaft has been repaired by grinding or pressing,
inspect the crankshaft for cracks and other harmful damage
using a magnetic particle method.
Measuring bend of crankshaft
4.11 Replacing crankshaft gear
4.11.1 Removing crankshaft gear
Using a gear puller, remove the gear from the crankshaft.
Note: Do not strike the gear with a hammer.
Removing crankshaft gear
4.11.2 Installing crankshaft gear
(1) Install the key on the crankshaft.
(2) Press-fit the gear fully in alignment with the key.
Installing crankshaft gear
Item Standard Remark
Crankshaft runout
0.06 mm
[0.0024 in.]
TIR
Gear puller
Aligning position
To Next Page
Loading...
