Mitsubishi L2A

GENERAL
1-8
Lubrication system
Lubrication system Pressure feed, full flow filter system
Engine oil
Speci fication API service category CF and CF-4
Capacity
(engine total)
Upper limit: 2.0 L [0.53 U.S. gal]/
Lower limit: 1.2 L [0.32 U.S. gal]
(Upper limit: 2.5 L [0.66 U.S.gal]/
Lower limit: 1.7 L [0.45 U.S. gal])
Oil pump
Type
Gear type (internal and external teeth engagement),
built into gear case
Discharge rate
3 L [0.79 U.S. gal]/min or more (at 1000 min
-1
)
Relief valve
Type Plunger valve type
Valve opening pressure
0.29 ± 0.029 MPa {3.0 ± 0.3 kgf/cm²}
[42.68 ± 4.3 psi] (1000 min
-1
)
Oil filter Type Paper-element cartridge
Cooling
system
Cooling system Forced-feed circulation type
Coolant capacity (main unit of engine) 1.2 L [0.32 U.S. gal]
Water pump
Type Centrifugal volute type
Discharge rate
50 L [13.21 U.S. gal]/min
(at pump rotation of 4500 min
-1
)
Thermostat
Type Wax pellet
Valve opening pressure 76.5 ± 1.5°C [169.7 ± 2.7°F]
Cooling fan
Type Suction (PP fan)
No. of blades/
Outside diameter
4 variable pitch blades/260 mm [10.24 in.]
Inlet
system
Air cleaner Type Paper element
Table 1-1 Specifications of L2A, L2C and L2E (2 / 4)
Engine model L2A L2C L2E