Mitsubishi LS2-210 - Machine Stop Position Adjustment

4. PREPARATIONS BEFORE OPERATION
4.1 Installation of Sewing Machine and Motor
Balance wheel
Synchronizer
Face Plate-*
Phase-reversing
plug
LIMI-STOP
clutch motor
Control box
Plugs from machine
Rubber pad
POWER ON/OFF switch
Switch panel
Passing the Machine Cords
Round hole in table
Switch panel
,.-1-
CLUTCH
BRAKE
SPEED
NEEDLE POSITION
0
Wiring between sewing machine and control box
Note: Beforeplugging or unplugging, be sure to turn off the POWER ON/OFF pushbutton.
Pass two cables from the sewing machine through the round hole in the table and connect the two
plugs into the respective plug receptacles.
8
From the library of: Superior Sewing Machine & Supply LLC