Mitsubishi Mahindra GX3600 - Page 44

40
SPECIFICATIONS
10. Inspection and Replacement of Transmission Oil
Inspection
- Remove the oil filler plug and make sure that
the oil level gauge indicates within the range
between the upper limit and lower limit
(specified amount).
- When the engine is running, the oil level
lowers. When checking the oil level, stop the
engine and wait for five minutes.
- Check the oil level before starting the
engine.
Oil Supply
- Supply oil to the upper limit of the oil level
gauge when sufficient.
Oil Replacement
(1) Remove the drain oil plug located in the
bottom part of the center of transmission
housing and drain the oil.
1944_0064
Oil Filler Plug
(with Oil Level Gauge)
Oil Filler Plug
(with Oil Level Gauge)
[Upper Limit]
[Lower Limit]
Specified
Amount
For injury prevention
- Place the tractor on flat place and stop
the engine when inspecting and
replacing the transmission oil.
WARNING
1944_0065
Drain Oil Plug
(2) Close the drain oil plug and supply new gear
oil to the upper limit of the oil level gauge.
NOTE
- Check the oil level before starting the
engine.