Mitsubishi MELSEC-A A1SHCPU - Page 148

122
"LINK PARA.
ERROR"
47
471*
Continue
[When using
MELSECNET/10]
(1) The transfer source
device range and
transfer destination
device range
specified for the
inter-network transfer
parameters are in the
same network.
(2) The specified range
of transfer source
devices or transfer
destination devices
for the inter-network
transfer parameters
spans two or more
networks.
(3) The specified range
of transfer source
devices or transfer
destination devices
for the inter-network
transfer parameters is
not used by the
network.
Write the network
parameters again
and check.
472*
[When using
MELSECNET/10]
The contents of the
routing parameters written
from a peripheral device
differ from the actual
network system.
Write the routing
parameters again
and check.
Table 6.3 Error Code List for A2ASCPU(S1/S30) and A2USHCPU-S1 (Continue)
Error
Massage
Error
Code
(D9008)
Detailed
Error
Code
(D9091)
CPU
States
Error and Cause Corrective Action